Velleman PEM10D2 Manual de usuario descargar pdf (Pagina 7)

PEM10D2

V. 02 – 27/11/2013 7 ©Velleman nv

• Guide the control cables through the back or cable gland of the

housing. Tighten the cable gland.

• Make the proper connections to the terminals (see §5).

Note:

o to facilitate the connections of the wiring, lift the sensor

assembly from the housing.

o To do this, release the 4 screws [L] (2 large ones on top, 2

small ones near the bottom).

After making all connections gently reseat the sensor assembly

and put the 4 screws back.

• Attach the housing to the mounting bracket and secure it with the

two mounting bolts [J].

• Apply power to the system. The alignment LED [D] will turn red

since no reflector is detected.

• Place the reflector in line with the transmitter/receiver lens [C]

until the alignment LED [D] turns green. Mark the position of the

reflector and mount it in that location.

• Note: the lens can be aligned horizontally (±25°) by rotating the

entire lens head (do not force) or vertically using the vertical

alignment bolt [F].

• Close the cover [H] with the 4 screws and slide the hood [A] in

pla ce .

• Note: by closing the cover, the tamper switch [E] is pressed and

the tamper contact [6]/[7] is closed.

7. Operation

• When the beam between transmitter and receiver is broken, the

alignme nt LED [D] turns red and an alarm is triggered on the

output contacts until the beam is restored:

o [3] - [5]: open contact

o [4] - [5]: closed contact

• When the alignment LED [D] flashes red and green alternately an

alignment problem occurs. Open the cover and slowly adjust the

horizontal and/or vertical angle [F] of the lens [C].

• In case somebody opens the cover, the tamper switch [E] is

released and the tamper contact is closed:

o [6] – [7]: closed contact

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Sin comentarios

Velleman PEM10D2 Manual de usuario Pagina 7