Velleman VTSDIR Manual de usuario Pagina 1

V IN US VTSDNFRA-RESER MANDIR ED SMD &UAL & BGA REEWORK S3STATION N

VTSDIR 21.03.2011 ©Velleman nv 10Appendix 2

VTSDIR 21.03.2011 ©Velleman nv 11

Velleman® Service and Quality Warranty Velleman® has over 35 years of experience in the electronics world and distributes its products in more than

VTSDIR 21.03.2011 ©Velleman nv 2 Main station front panel Main station rear panel Figure

211.ToImThtheThcomPlekeeFowe2.1. 2. 3. 4. 5. 6. 7. 8. 9. 10To1. 2. 3. 4. 5. 6. 7. • • • .03.2011 . Introduo all residenmportant enThis sharm be tak

21• • • • 3.Re• • • • 4.ReMa1. 2. 3. 4. 5. 6. 7. 8. 9. 10Ma111213141516Ma17181920215.ThopHosol MeNoPro .03.2011 The systempre-heater,for the equDeath

VTSDIR 21.03.2011 ©Velleman nv 56. Setup Refer to the illustrations on page 2 of this manual. Note: never unplug any connection during operation. •

21P T8.• • • .03.2011 PreparationThe proced• Switch• Set ‘co• Sort toThe followin• SMT Tw• Flux di• Low soTemperaturIn normal osystem is d150W s

VTSDIR 21.03.2011 ©Velleman nv 7• How long do I preheat the PCB? Always preheat the PCB (up to 120°C or between 45 – 90 seconds) to allow the heat

VTSDIR 21.03.2011 ©Velleman nv 8Appendix 1 Remove screws [X], remove metal bar [Y] and remove plastic tubes [Z].

VTSDIR 21.03.2011 ©Velleman nv 9 Place the metal grid and secure it with the two screws [X].