Velleman DVR4MQAEE Manual de usuario descargar pdf (Pagina 38)

DVR4MQAEE_v5 VELLEMAN

- 38 -

HDD failure - Test with another HDD.

- Test with another HDD cable.

- Make sure HDD “Master” and “Slave” mode is set

correctly.

When two Seagate power-saving HDDs are installed,

the DVR cannot be switched on successfully

- Do not use 2 Seagate power-saving HDDs

simultaneously.

Cannot view the DVR over the network with a web

browser

- Update the JAVA programme.

- Update the firmware of the software AP.

12. Appendix #1 – HDD Installation

NOTE: Always set the HDD jumper on “CS” (Cable Select).

1 2 3

4 5

• Step 1: Loosen the screws of the top cover (2 per side + 4 on the back) and lift it (refer to figure 5 and 4).

• Step 2: Remove the HDD bracket by releasing the 4 screws.

• Step 3: Get a suitable IDE HDD and set the HDD mode to master. Note that an adapter is available (not incl.) to

enable the use of SATA disks with this DVR (reference: DVR/SATA).

• Step 4: Mount the HDD into the HDD cartridge. Screw the HDD to the cartridge using 2 screws on each side

(refer to figure 1 and 2).

• Step 5: Screw the HDD cartridge back in the DVR housing; connectors towards the back of the DVR (refer to

figure 3).

• Step 6: Connect the power connector and the IDE bus to the HDD. Make sure to use the correct pin alignment

for the IDE bus (pin 1 on motherboard connected with pin 1 of HDD).

• Step 7: Close the upper cover of the DVR and fasten all 8 screws (refer to figure 4 and 5).

1 2 ... 33 34 35 36 37 38 39 40 41

Sin comentarios

Velleman DVR4MQAEE Manual de usuario Pagina 38