Velleman VMB1TS Manual de usuario descargar pdf (Pagina 32)

32 VMB1TS manual – edition 2

Remotely set cooling mode

With the lower left button on the second page of the control panel the temperature sensor is set in cooling mode.

1. Remember the address of the sensor module to

reinstate it later.

2. Set the address of the sensor module to ‘A1’.

The cooling mode LED flashes to indicate learning

mode for pushbuttons that place the module in

cooling mode.

Remark:

When multiple sensor modules needs to react to

the same pushbutton, remember their addresses

and set them also to ‘A1’.

3. Select the second page of the control panel by

pressing the small pushbutton.

4. Press and hold the ‘Cooling’ pushbutton

(at least 1 second) until its indication LED starts

flashing.

Remark:

As long as the pushbutton is pressed, the LEDs on

the sensor module will be off. This to confirm that

the pushbutton is assigned.

5. Repeat step 4 in case other pushbuttons must set

the sensor module in cooling mode.

6. Reinstate the address of the sensor module(s) to

its (their) original value.

ADDR = A1



Heating Lock

Cooling Unlock



Heating Lock

Cooling Unlock

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 42 43

Sin comentarios

Velleman VMB1TS Manual de usuario Pagina 32