Velleman К8075 Manual de usuario descargar pdf (Pagina 9)

 Cut off a piece of shrinkable tube with a lenght equal to 2,5cm.

 Slide the shrinkable tube over the wires of the female 'board to wire'-connector (fig. 2.0)

 Solder the 4-pole female 'board to wire' connector to the push button using the figure

below to check the accuracy of the connections (see figure 3.0)

 Attention: Always make sure to slide down the shrinking tube far enough from the soldering points!

 Slide the shrinkable tube over the soldered joints and heat them using a hair dryer or, better still, using a

paint stripper.

18. Wiring the push button

(Orange)

(Red)

(Yellow)

3 4

(Brown)

Leen d :

LED -

LED +

Push button

Wiring the push button

Fig. 2.0

(Yellow)

(Orange)

(Brown)

(Red)

Fig. 3.0

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Velleman К8075 Manual de usuario Pagina 9