Velleman VM152 Manual de usuario descargar pdf (Pagina 6)

Changing the code :

Return to the default code :

1. Hold SW1 (left button)

2. Briefly press the 'program'-button (SW3) 3 times. The LED will flash 3 times.

3. Release SW1.

4. Your unique 32-bit code has been generated and stored.

1. Hold SW1 (left button).

2. Hold the 'program'-button (SW3). After +/- 10s the led will flash 5 times.

3. Release both buttons.

4. Your code has been reset to the default code.

Turn off the power (disconnect power supply)

Hold buttons 3 & 4 pressed

Turn on power (connect power supply)

The Led's start flashing

Release buttons 3 & 4 after the LED’s turn off

This process takes about 10 seconds.

If the button is released before the LED’s turn off, the memory will not be cleared.

The unit will now respond to the default code only. please also reset the transmitter to the

default code.

Receiver: remove all learned remotes from memory and return to default code

Transmitter

3 4

SW3

SW1

SW2

LED

transmitter & receiver settings

vm152G'1_rev2.pub

page 6

Wednesday, September 26, 2012 14:16

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Sin comentarios

Velleman VM152 Manual de usuario Pagina 6