Velleman K8200 Manual de usuario Pagina 14

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 45
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 13
These drivers control the current that flows through each motor. To do that correctly each of them needs to be
calibrated. Take your multimeter and a ceramic screwdriver (a normal screwdriver will also work but be very
careful not to touch anything else but the trimmer on the driver boards as you can cause a short circuit).
Put your multimeter on 2V DC and put the negative lead on the negative screw of the power connector. Put the
positive lead on the large via of the first motor driver (for the extruder motor). BE VERY CAREFUL NOT TO TOUCH
ANYTHING ELSE WITH THE POSITIVE LEAD OF YOUR MULTIMETER.
Vista de pagina 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 44 45

Comentarios a estos manuales

Sin comentarios