Velleman K8200 Manual de usuario descargar pdf (Pagina 32)

If everything went right so far you know that the extruder will work, now we will test the HEATED BED PCB.

Make sure the temperature for the HEATED BED PCB is set at 50°C.

Now press the button “Heat Printbed”.

(When you do this you can also see an indicator light on the controller board lighting up, showing that HEATER 2 is

powered).

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 44 45

Sin comentarios

Velleman K8200 Manual de usuario Pagina 32