Velleman CAMSCC3G Ficha de datos descargar pdf (Pagina 6)

CAMSCC3G

Components nv

8. Activation

Connecting the Charger

• Insert the charger into the CAMSCC3G as indicated in the illustration on page 3 of this

manual.

• Plug the charger into the 12VDC input [F].

• The Battery and Network lights on the device will turn red and flash rapidly (once every

second) on an off during this first phase.

• Once the device registers that a charger has been inserted, the battery LED [H] will turn

on. Battery status is described in the figures below.

• If the battery LED [H] is red and flashes rapidly (once every second), it is out of charge.

The battery takes approximately 30 minutes to charge up to its minimum operative level.

Do not switch on the device if the battery is below its minimum operative level. If the

battery LED [H] is on and flashing slowly (once every 3 seconds), the battery has been

charged up to its minimum operative level.

• Battery status is described in the figure below.

• The network LED [J] will display a yellow light while the device searches for the UMTS

network. This will then turn green and start flashing rapidly. The LED will show battery

levels after it has measured battery capacity. Network status is described below.

• Once the device is connected to the network, the network LED [J] will turn green and

stops flashing.

• The device and all its functions are ready for use once the network LED [J] turns green

and the battery LED [H] displays the level charge the battery has.

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Sin comentarios

Velleman CAMSCC3G Ficha de datos Pagina 6