Velleman PCUSBVGA2 Manual de usuario descargar pdf (Pagina 4)

PCUSBVGA

5. Windows driver installation

• Before connecting the device to the PC, drivers must be installed. Close all applications before

continuing.

• Place the included CD-ROM in the CD-reader. Note: only insert the disc in a loader that supports

mini-CD ROMs (8cm/3.15”).

• When auto-play is enabled, the installation program starts automatically. If not, locate and double

click Setup.exe on the CD-ROM.

NOTICE:

→ Windows Vista: the User Account Control dialog box pops up when attempting to install a

program. Enter an administrator password or click ‘Allow’ to start the installation.

→ Windows 2000: Make sure all necessary Service Packs are present on the system.

• In the opening screen (see below), click on the applicable operating system.

• A window with the user licence agreement pops up (see above). Read it through and click on ‘I

accept’ to continue installation.

• The system needs to be rebooted to finalize the installation. Click ‘Yes’ when the reboot prompt

appears.

6. Adaptor installation

• Refer to the illustrations on page 2 of this manual.

• Plug the type B-connector (smaller) of the included USB cable into the ‘mini-B’ USB port [A] of the

PCUSBVGA. Plug the USB type A-connector (larger) into a free USB 2.0 port of the computer.

NOTICE:

→ The USB port must be type USB 2.0 or higher

• Connect the DVI port [B] of the PCUSBVGA to a monitor. If the monitor has a DVI connector, use

a normal DVI cable (not incl.). To connect to an analogue VGA or HDMI monitor, use the

appropriate adaptor (included).

• Switch on the monitor; the status LED [C] lights up. Windows will automatically finalize the

installation and the monitor will become active.

NOTICE:

→ Windows Vista: it is possible that the screen remains blank. In this case, reboot the system

again.

→ During installation, the added screen might flicker a couple of times. This is normal

behaviour.

→ There might be some delay before a first image is seen on the added screen.

→ Windows Vista Aero interface: the USB adaptor is not compatible with the Vista aero

interface. The interface is disabled and a warning that the colour scheme has been changed

is given. Unplug or uninstall the USB adaptor to automatically re-enable the Aero interface.

1 2 3 4 5 6 7 8 9 ... 48 49

Sin comentarios

Velleman PCUSBVGA2 Manual de usuario Pagina 4